Doro Titan Průvodce řešením problémů stáhnout pdf (Strana 3)

English

www.doro.com 3

Installation

Battery

To ensure that messages and time/date information will be retained during a

possible power cut (max. 16 hours), a 9V – PP3 battery is required (not supplied).

When the battery is running low, the display will ash Lo, change the battery as

soon as possible.

Use only a high quality Alkaline battery.

1. Ensure the telephone line cord is disconnected.

2. Remove the battery cover.

3. Connect the battery observing correct polarity.

4. Replace the battery cover.

Connection

Once the back-up battery has been installed.

1. Connect the telephone line cord to the T socket at the rear of the unit.

2. Connect the other end into the telephone network wall socket (using adapter

plug if required).

3. You will hear a click when the modular plug is correctly in place.

4. Connect the mains adapter to the DC 9V socket at the rear of the unit and then

to an electrical wall socket.

5. The unit will enter the initial start mode which takes about 30 seconds. During

this time the display will show

. When initialisation is complete the unit will

emit four tones.

6. Before you use the answering machine you should record an outgoing message

(please refer to page 6). You should also set the day/time stamp function (please

refer to page 4).

Warning!

Only use the supplied power adapter (9VDC).

Switching the Answering Machine On/Off

The answering machine can be switched ON or OFF using the ! button. In the

ON position, incoming calls will be answered by the answering machine, in the

OFF position no calls will be answered and the display will be off.

Please note!

Although turned Off, the Answering Machine will answer a call after 16 Rings. This is to allow

the remote ON and other features to be accessed.

1 2 3 4 5 6 7 8 ... 15 16

Žádné komentáře

Doro Titan Průvodce řešením problémů Strana 3